en:x200:move_to_xyz_key
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x200:move_to_xyz_key [2025/04/22 12:10] erik.ketele |
en:x200:move_to_xyz_key [2025/04/22 12:12] (current) erik.ketele |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Move to XYZ-coordinate ====== | ====== Move to XYZ-coordinate ====== | ||
| - | The MOVE command allows you to enter exact values for X, Y, or Z (0,0,0) where the first entry is X, the second entry is Y, and the third entry is Z. The X, Y, and Z values will reference from the machine’s Hard Home position until the SET HOME and SET SURFACE commands have been selected. At that point the X and Y axis will reference from the Set Home position. The Z value will reference from the surface of the material. | + | The MOVE command allows you to enter exact values for X, Y, or Z (0,0,0) where the first entry is X, the second entry is Y, and the third entry is Z. \\ |
| + | The X, Y, and Z values will reference from the machine’s Hard Home position until the SET HOME and SET SURFACE commands have been selected.\\ | ||
| + | At that point the X and Y axis will reference from the Set Home position. The Z value will reference from the surface of the material | ||
| To Move To A Specific Location. | To Move To A Specific Location. | ||
en/x200/move_to_xyz_key.1745316656.txt.gz · Last modified: 2025/04/22 12:10 by erik.ketele
