en:x200:move_to_xyz_key
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x200:move_to_xyz_key [2025/04/22 12:10] erik.ketele |
en:x200:move_to_xyz_key [2025/04/22 12:12] (current) erik.ketele |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Move to XYZ-coordinate ====== | ====== Move to XYZ-coordinate ====== | ||
| - | The MOVE command allows you to enter exact values for X, Y, or Z (0,0,0) where the first entry is X, the second entry is Y, and the third entry is Z. The X, Y, and Z values will reference from the machine’s Hard Home position until the SET HOME and SET SURFACE commands have been selected. At that point the X and Y axis will reference from the Set Home position. The Z value will reference from the surface of the material. | + | The MOVE command allows you to enter exact values for X, Y, or Z (0,0,0) where the first entry is X, the second entry is Y, and the third entry is Z. \\ |
| + | The X, Y, and Z values will reference from the machine’s Hard Home position until the SET HOME and SET SURFACE commands have been selected.\\ | ||
| + | At that point the X and Y axis will reference from the Set Home position. The Z value will reference from the surface of the material | ||
| To Move To A Specific Location. | To Move To A Specific Location. | ||
| Line 21: | Line 23: | ||
| After the move you will see the new coordinates in the top part of the pendent window:\\ | After the move you will see the new coordinates in the top part of the pendent window:\\ | ||
| {{: | {{: | ||
| - | |||
| - | === Note: === | ||
| - | |||
| - | When the X, Y, or Z value comes up it will be in the current location of that axis. If the current location is required select MOVE and Press ENTER three times. This will display the current location. To keep an axis from moving Press ENTER when the axis value comes up. | ||
| \\ | \\ | ||
en/x200/move_to_xyz_key.1745316615.txt.gz · Last modified: 2025/04/22 12:10 by erik.ketele
