Differences

This shows you the differences between two versions of the page.

--- en:x200:machine_opening_the_drawer [2025/04/23 16:15]
erik.ketele
+++ en:x200:machine_opening_the_drawer [2025/04/24 12:10] (current)
erik.ketele
@@ Line 9: / Line 9: @@
    - Remove the ethernet cable from the ethernet socket.
-{{:en:x200:drawerscrews.png?800|image}} \\  \\ On the above image the green arrows indicate the 2 screws which have to be removed. \\  \\
+{{:en:x200:drawerscrews.png?800|image}} \\ On the above image the green arrows indicate the 2 screws which have to be removed. \\  \\
-{{:en:x200:dsc03883.jpg?800}} \\ Gently pull the drawer to the rear. \\ When you encounter a resistance push the 2 sides down and pull further backwards.
+{{:en:x200:dsc03883.jpg?800}} \\ Gently pull the drawer to the rear. \\ When you encounter a resistance push the 2 sides down and pull further backwards. \\  \\
+{{:nl:x200:elektronics.jpg?800}} \\ Finally you can pull the drawer out as far as needed. \\  \\
+{{:en:x200:dsc03886.jpg?800}} \\ When pushing the drawer back inside the machine chassis, pay attention to the wire harness on the right. \\ Make sure nothing obstructs this harness. \\  \\
-**Continue to [[:en:x200:greasing_the_leadscrews|greasing the leadscrews]].** \\
+**Continue to [[:en:x200:Machine_not_initializing|Trouble shooting, The machine does not initialize]].** \\
 **Continue to [[:en:x200:table_of_contents|the table of contents]].**

cyborg-engravers