Differences

This shows you the differences between two versions of the page.

--- en:x200:machine_opening_the_drawer [2025/04/23 16:13]
erik.ketele
+++ en:x200:machine_opening_the_drawer [2025/04/24 12:10] (current)
erik.ketele
@@ Line 9: / Line 9: @@
    - Remove the ethernet cable from the ethernet socket.
-{{:en:x200:drawerscrews.png?800|image}} \\  \\ On the above image the green arrows indicate the 2 screws which have to be removed. \\  \\
+{{:en:x200:drawerscrews.png?800|image}} \\ On the above image the green arrows indicate the 2 screws which have to be removed. \\  \\
-Follow the 4 steps below to take off the timing belt from the spindle. \\  \\
+{{:en:x200:dsc03883.jpg?800}} \\ Gently pull the drawer to the rear. \\ When you encounter a resistance push the 2 sides down and pull further backwards. \\  \\
-{{:en:x200:dsc03883.jpg?800}} \\ 1. Spindle with cutter and cutter knob \\ 2. spindle with cutter and cuuter knob removed \\ 3. Rotate spindle clockwise and simultaneously move the belt up on the spindle pulley \\ 4. Finally the timing belt will come off the spindle pulley. \\  \\ When putting on a new belt, first put it around the spindle motor pulley, then rotate it clockwise over the spindle pulley.
+{{:nl:x200:elektronics.jpg?800}} \\ Finally you can pull the drawer out as far as needed. \\  \\
+{{:en:x200:dsc03886.jpg?800}} \\ When pushing the drawer back inside the machine chassis, pay attention to the wire harness on the right. \\ Make sure nothing obstructs this harness. \\  \\
-**Continue to [[:en:x200:greasing_the_leadscrews|greasing the leadscrews]].** \\
+**Continue to [[:en:x200:Machine_not_initializing|Trouble shooting, The machine does not initialize]].** \\
 **Continue to [[:en:x200:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Differences

Page Tools