Differences

This shows you the differences between two versions of the page.

--- en:x200:machine_opening_the_drawer [2025/04/23 15:55]
erik.ketele
+++ en:x200:machine_opening_the_drawer [2025/04/24 12:10] (current)
erik.ketele
@@ Line 6: / Line 6: @@
    - Before opening the electronics drawer, make sure to switch off the power to the machine.
-   - Remove the power cord from that socket.
+   - Remove the power cord from the power socket.
    - Remove the ethernet cable from the ethernet socket.
-{{:en:x300:dsc_9155.jpg?600|ASCII}} \\  \\ On the above image it is clearly visible that there is no strain on the timing belt. \\  \\ Follow the 4 steps below to take off the timing belt from the spindle. \\  \\ {{:en:x300:remove_belt.png?1200}} \\ 1. Spindle with cutter and cutter knob \\ 2. spindle with cutter and cuuter knob removed \\ 3. Rotate spindle clockwise and simultaneously move the belt up on the spindle pulley \\ 4. Finally the timing belt will come off the spindle pulley. \\  \\ When putting on a new belt, first put it around the spindle motor pulley, then rotate it clockwise over the spindle pulley.
+{{:en:x200:drawerscrews.png?800|image}} \\ On the above image the green arrows indicate the 2 screws which have to be removed. \\  \\
+{{:en:x200:dsc03883.jpg?800}} \\ Gently pull the drawer to the rear. \\ When you encounter a resistance push the 2 sides down and pull further backwards. \\  \\
+{{:nl:x200:elektronics.jpg?800}} \\ Finally you can pull the drawer out as far as needed. \\  \\
+{{:en:x200:dsc03886.jpg?800}} \\ When pushing the drawer back inside the machine chassis, pay attention to the wire harness on the right. \\ Make sure nothing obstructs this harness. \\  \\
-**Continue to [[:en:x200:greasing_the_leadscrews|greasing the leadscrews]].** \\
+**Continue to [[:en:x200:Machine_not_initializing|Trouble shooting, The machine does not initialize]].** \\
 **Continue to [[:en:x200:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Differences

Page Tools