en:x200:machine_not_initializing
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
en:x200:machine_not_initializing [2025/04/23 10:35] erik.ketele created |
en:x200:machine_not_initializing [2025/10/01 12:25] (current) erik.ketele |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| 2. Does your wall outlet supply power ? Did you measure it with a multimeter ?\\ | 2. Does your wall outlet supply power ? Did you measure it with a multimeter ?\\ | ||
| 3. Are the two glass fuses inside the main filter still OK ? They sit just near the power cord socket. Check them with an Ohm-meter.\\ | 3. Are the two glass fuses inside the main filter still OK ? They sit just near the power cord socket. Check them with an Ohm-meter.\\ | ||
| - | 4. When switching on the machine, do you hear the fan and do you hear the motors locking? | + | 4. When switching on the machine, do you hear the fan and do you hear the motors locking? If not, the power switch might be defective.\\ |
| 5. If the power switch is OK, the 48 VDC power supply might be defective. It feeds the fan and the step drives.\\ | 5. If the power switch is OK, the 48 VDC power supply might be defective. It feeds the fan and the step drives.\\ | ||
| - | 6. With the protective cover OPEN, and trying to home the spincle {{: | + | 6. With the protective cover OPEN, and trying to home the spincle {{: |
| - | 7. If you see this image and the machine does still not initialize when pushing {{: | + | 7. If you see this image and the machine does still not initialize when pushing {{: |
| - | + | **Continue to [[:en:x200:spindle_not_rotating|trouble shooting, | |
| - | **Continue to [[spindle_not_rotating|trouble shooting, spindle does not rotate]].**\\ | + | |
| **Continue to [[: | **Continue to [[: | ||
| + | |||
| + | |||
en/x200/machine_not_initializing.1745397301.txt.gz · Last modified: 2025/04/23 10:35 by erik.ketele
