Differences

This shows you the differences between two versions of the page.

--- en:x200:increase_cut_speed_key [2025/04/22 09:12]
erik.ketele created
+++ en:x200:increase_cut_speed_key [2025/04/22 09:13] (current)
erik.ketele
@@ Line 7: / Line 7: @@
 The feedrate override will determine the amount that the cut speed will be adjusted by.
-When a file is being executed on the machine pressing the INCREASE CUT SPEED {{:en:x300:key_feedincrease.png?30}}hot key will increase the feedrate in 1% increments.
+When a file is being executed on the machine pressing the INCREASE CUT SPEED {{:en:x300:key_feedincrease.png?30}} hot key will increase the feedrate in 1% increments.
-Holding the INCREASE CUT SPEED {{:en:x300:key_feedincrease.png?30}}hot key increases the feedrate at an increasingly faster rate.\\
+Holding the INCREASE CUT SPEED {{:en:x300:key_feedincrease.png?30}} hot key increases the feedrate at an increasingly faster rate.\\
 \\
-**Return to [[:en:x300:keypad_overview|the keypad overview]].** \\
+**Return to [[:en:x200:keypad_overview|the keypad overview]].** \\
-**Continue to [[:en:x300:table_of_contents|the table of contents]].**
+**Continue to [[:en:x200:table_of_contents|the table of contents]].**

cyborg-engravers