Differences

This shows you the differences between two versions of the page.

--- en:x200:how_to_use_symmetry_engraving_depths [2025/04/18 15:20]
erik.ketele
+++ en:x200:how_to_use_symmetry_engraving_depths [2025/04/18 15:25] (current)
erik.ketele
@@ Line 5: / Line 5: @@
 When engraving the job the cutter will first perform a roughing pass at 0.4 mm depth, and after that a cleaning pas at 0.5 mm depth.
-{{:en:x200:passdepths_en.png?500}}
+{{:en:x200:pasdepths_en.png?500}}
-There is one important condition:\\
+__There is one important condition:__\\
 The Cyborg pendent software has to be set in such a way that the machine reads and executes the depths in the cnc-file.\\
 In the CNC-field "Z-move values" the option "From Job File" has to be active. (see image below)
@@ Line 13: / Line 13: @@
 {{:nl:x300:z_move_values_from_job_file.png?700}}
-**Ga verder naar [[:nl:x200:how_to_lock_the_spring_pressure|3.4.2.2. De veerdruk blokkeren om zonder diepteneus te graveren]].** \\
+**Continue to [[:en:x200:how_to_lock_the_spring_pressure|3.4.2.3. Locking the spring pressure ring to engrave without nosecone]].** \\
-**Ga verder naar [[:nl:x200:inhoudstafel|de inhoudstafel]].**
+**Continue to [[:en:x200:table_of_contents|the table of contents]].**

cyborg-engravers