en:x200:how_to_use_symmetry_engraving_depths
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
en:x200:how_to_use_symmetry_engraving_depths [2025/04/18 15:13] erik.ketele created |
en:x200:how_to_use_symmetry_engraving_depths [2025/04/18 15:25] (current) erik.ketele |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== 3.4.2.2. Entering engraving depths in Symmetry and using those while engraving ===== | ===== 3.4.2.2. Entering engraving depths in Symmetry and using those while engraving ===== | ||
| - | In Symmetry it is possible to enter the desired engraving depths. This happens in the following window.\\ | + | In Symmetry it is possible to enter the desired engraving depths. This happens in the following window |
| The numbers in the different fields function as an example:\\ | The numbers in the different fields function as an example:\\ | ||
| When engraving the job the cutter will first perform a roughing pass at 0.4 mm depth, and after that a cleaning pas at 0.5 mm depth. | When engraving the job the cutter will first perform a roughing pass at 0.4 mm depth, and after that a cleaning pas at 0.5 mm depth. | ||
| - | {{:nl:x300:symmetry_graveerdieptes.png?500}} | + | {{:en:x200:pasdepths_en.png?500}} |
| - | There is one important condition: | + | __There |
| The Cyborg pendent software has to be set in such a way that the machine reads and executes the depths in the cnc-file.\\ | The Cyborg pendent software has to be set in such a way that the machine reads and executes the depths in the cnc-file.\\ | ||
| In the CNC-field " | In the CNC-field " | ||
| Line 13: | Line 13: | ||
| {{: | {{: | ||
| - | **Ga verder naar [[:nl: | + | **Continue to [[:en: |
| - | **Ga verder naar [[:nl:x200:inhoudstafel|de inhoudstafel]].** | + | **Continue to [[:en:x200:table_of_contents|the table of contents]].** |
en/x200/how_to_use_symmetry_engraving_depths.1744982033.txt.gz · Last modified: 2025/04/18 15:13 by erik.ketele
