en:x200:greasing_the_leadscrews
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
Next revision
|
Previous revision
|
en:x200:greasing_the_leadscrews [2025/04/24 12:04]
erik.ketele |
en:x200:greasing_the_leadscrews [2025/04/24 12:08] (current)
erik.ketele |
| |{{ :en:x200:tablescrews-4.jpg?500 |{afbeelding}}|Remove 2 more screws which are indicated with a green arrow on the image on the left. \\ You can lift up the leadscrew cover and put it on the side. | | |{{ :en:x200:tablescrews-4.jpg?500 |{afbeelding}}|Remove 2 more screws which are indicated with a green arrow on the image on the left. \\ You can lift up the leadscrew cover and put it on the side. | |
| |{{ :en:x200:dsc03898.jpg?500 |{afbeelding}}|After having taken away the leadscrew cover you have access to the Y-axis leadscrew.\\ Clean the area which is normally covered by the engraving table and the leadscrew cover.\\ Do so using a vacuum cleaner, do not use compressed air.\\ Apply some grease to the leadscrew, just behind the leadscrew nut.\\ After having applied some grease you can re-assemble the leadscrew cover and the engraving table.| | |{{ :en:x200:dsc03898.jpg?500 |{afbeelding}}|After having taken away the leadscrew cover you have access to the Y-axis leadscrew.\\ Clean the area which is normally covered by the engraving table and the leadscrew cover.\\ Do so using a vacuum cleaner, do not use compressed air.\\ Apply some grease to the leadscrew, just behind the leadscrew nut.\\ After having applied some grease you can re-assemble the leadscrew cover and the engraving table.| |
| |{{ :en:x200:dsc03896.jpg?500 |{afbeelding}}|Gently rotate the black knob on the back side of the X-axis stepper motor till the flat side of the cutter is well aligned with the left table stop.| | |{{ :en:x200:dsc03896.jpg?500 |{afbeelding}}|The X-axis leadscrew is easily accessible.\\ clean the leadscrew with a soft dry cloth.\\ Then apply some grease on it.| |
| |{{ :en:x200:dsc03899.jpg?500 |{afbeelding}}|Now check if the finely engraved line on this knob corresponds with the engraved line on the indicator plate.\\ If that is not the case, loosen the black knob and rotate it to properly align it with the engraved indicator plate.| | |{{ :en:x200:dsc03899.jpg?500 |{afbeelding}}|The Z-axis leadscrew is also easily accessible.\\ using the Z-axis jog keys move the spindle down and the Z leadscrew will become visible.\\ Apply some grease and move the spindle up again.|\\ |
| | |Re-tighthen this knob.|\\ | |
| | |Screw the depth regulator nose back onto the spindle.| | |
| |
| |
en/x200/greasing_the_leadscrews.1745489098.txt.gz · Last modified: 2025/04/24 12:04 by erik.ketele
