en:x200:greasing_the_leadscrews
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
Next revision
|
Previous revision
|
en:x200:greasing_the_leadscrews [2025/04/24 11:38]
erik.ketele |
en:x200:greasing_the_leadscrews [2025/04/24 12:08] (current)
erik.ketele |
| - The X-axis and the Z-axis leadscrews are easily accessible, applying some grease is easily done there. | - The X-axis and the Z-axis leadscrews are easily accessible, applying some grease is easily done there. |
| - Before putting grease on the leadscrews, make sure they are absolutely clean. Use a soft dry cloth to clean them. | - Before putting grease on the leadscrews, make sure they are absolutely clean. Use a soft dry cloth to clean them. |
| - The Y-axis leadscrew sits under the engraving table and under a metal cover, both of which will have to be removed to get acces to them. | - The Y-axis leadscrew sits under the engraving table and under a metal cover, both of which will have to be removed to get acces to them.\\ |
| | |
| | ^Image ^Description | |
| | |{{ :en:x200:tablescrews-1.jpg?500 |{afbeelding}}|Remove the 4 screws which are indicated with a green arrow on the image on the left.| |
| | |{{ :en:x200:tablescrews-2.jpg?500 |{afbeelding}}|Remove 4 more screws which are indicated with a green arrow on the image on the left. \\ You can lift up the engraving table and put it on the side.| |
| | |{{ :en:x200:tablescrews-3.jpg?500 |{afbeelding}}|Remove the 2 screws which are indicated with a green arrow on the picture on the left.| |
| | |{{ :en:x200:tablescrews-4.jpg?500 |{afbeelding}}|Remove 2 more screws which are indicated with a green arrow on the image on the left. \\ You can lift up the leadscrew cover and put it on the side. | |
| | |{{ :en:x200:dsc03898.jpg?500 |{afbeelding}}|After having taken away the leadscrew cover you have access to the Y-axis leadscrew.\\ Clean the area which is normally covered by the engraving table and the leadscrew cover.\\ Do so using a vacuum cleaner, do not use compressed air.\\ Apply some grease to the leadscrew, just behind the leadscrew nut.\\ After having applied some grease you can re-assemble the leadscrew cover and the engraving table.| |
| | |{{ :en:x200:dsc03896.jpg?500 |{afbeelding}}|The X-axis leadscrew is easily accessible.\\ clean the leadscrew with a soft dry cloth.\\ Then apply some grease on it.| |
| | |{{ :en:x200:dsc03899.jpg?500 |{afbeelding}}|The Z-axis leadscrew is also easily accessible.\\ using the Z-axis jog keys move the spindle down and the Z leadscrew will become visible.\\ Apply some grease and move the spindle up again.|\\ |
| |
| |
en/x200/greasing_the_leadscrews.1745487523.txt.gz · Last modified: 2025/04/24 11:38 by erik.ketele
