en:x200:fixing_engraving_material
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
en:x200:fixing_engraving_material [2025/04/17 16:40] erik.ketele created |
en:x200:fixing_engraving_material [2025/04/28 11:56] (current) erik.ketele |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| ==== Using the standard " | ==== Using the standard " | ||
| - | {{: | + | {{: |
| To secure the engraving material to this table you first have to put the sticky “Multimat” (standard included) on the engraving table. You then put the engraving material on the Multimat. The Multimat has 2 sticky sides. It will firmly hold the engraving material to the engraving table. | To secure the engraving material to this table you first have to put the sticky “Multimat” (standard included) on the engraving table. You then put the engraving material on the Multimat. The Multimat has 2 sticky sides. It will firmly hold the engraving material to the engraving table. | ||
| + | ==== Using the optional quicklock vise ==== | ||
| - | ==== Using the optional quick lock vise ==== | + | {{:en:x200:dsc03906.jpg?600|Quicklock vise X-200}} |
| - | + | ||
| - | {{:en:x300:dsc_8450.jpg?nolink& | + | |
| The quick lock vise can be placed on the standard flat engraving table. Using 4 fixing screws it is secured to the left and the right side of the engraving table. This vise can be equipped with different clamping bars. | The quick lock vise can be placed on the standard flat engraving table. Using 4 fixing screws it is secured to the left and the right side of the engraving table. This vise can be equipped with different clamping bars. | ||
| - | + | **Continue to [[:en:x200:tool_setup|setting up a tool]].** \\ | |
| - | **Continue to [[tool_setup|setting up a tool]].**\\ | + | |
| **Continue to [[: | **Continue to [[: | ||
en/x200/fixing_engraving_material.1744900853.txt.gz · Last modified: 2025/04/17 16:40 by erik.ketele
