en:x200:find_machine_origin
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
en:x200:find_machine_origin [2025/04/22 08:49] erik.ketele |
en:x200:find_machine_origin [2025/04/22 08:49] (current) erik.ketele |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| It has to be positioned exactly above the upper left corner of the engraving table. On the back side of the X-motor and the Y-motor there is a black knob with a small engraved line.\\ | It has to be positioned exactly above the upper left corner of the engraving table. On the back side of the X-motor and the Y-motor there is a black knob with a small engraved line.\\ | ||
| Make sure that these engraved lines correspond with the black lines on the little engraved plates on the machine chassis.\\ | Make sure that these engraved lines correspond with the black lines on the little engraved plates on the machine chassis.\\ | ||
| - | After having verified the alignment position of the motors switch on the machine and hit the SHIFT {{: | + | After having verified the alignment position of the motors switch on the machine and hit the SHIFT {{: |
| \\ | \\ | ||
| Keypad status line display:\\ | Keypad status line display:\\ | ||
en/x200/find_machine_origin.1745304577.txt.gz ยท Last modified: 2025/04/22 08:49 by erik.ketele
