en:x200:depth_regulator_nose_use
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
Next revision
|
Previous revision
|
en:x200:depth_regulator_nose_use [2025/04/18 09:58]
erik.ketele |
en:x200:depth_regulator_nose_use [2025/04/18 15:00] (current)
erik.ketele |
| {{:nl:x200:x200_setsurface.png?200 }}* The number "9.23" in the image on the left is a random number, it can also be another number, depending on how far you move the spindle down. \\ * If you now click on the "Enter" button in this window the actual position becomes Z=0.0, \\ * The spindle then moves 5.0 mm up (if the "Z lift after setting surface" variable is set to 5.00) \\ * When engraving a job the spindle moves down to Z=0.0 and then 2.0 mm deeper (if the "Z depth value" was set to 2.00) \\ * The spring pressure system makes the spring compress 2.0 mm. \\ * Between 2 engraved characters the Z-axis motor will move 6.0 mm up (if the "Z depth value = 2.00" and the "Z lift value = 4.00"). \\ * Now start your engraving job. At the first Z down move the spindle will reach the material surface. At that point the spindle cannot go any deeper. The Z-motor however rotates a bit further... \\ * The spindle spring pressure becomes active. \\ \\ \\ \\ \\ \\ \\ | {{:nl:x200:x200_setsurface.png?200 }}* The number "9.23" in the image on the left is a random number, it can also be another number, depending on how far you move the spindle down. \\ * If you now click on the "Enter" button in this window the actual position becomes Z=0.0, \\ * The spindle then moves 5.0 mm up (if the "Z lift after setting surface" variable is set to 5.00) \\ * When engraving a job the spindle moves down to Z=0.0 and then 2.0 mm deeper (if the "Z depth value" was set to 2.00) \\ * The spring pressure system makes the spring compress 2.0 mm. \\ * Between 2 engraved characters the Z-axis motor will move 6.0 mm up (if the "Z depth value = 2.00" and the "Z lift value = 4.00"). \\ * Now start your engraving job. At the first Z down move the spindle will reach the material surface. At that point the spindle cannot go any deeper. The Z-motor however rotates a bit further... \\ * The spindle spring pressure becomes active. \\ \\ \\ \\ \\ \\ \\ |
| |
| **Ga verder naar [[:en:x200:spindle_pressure_spring|the use of the spindle spring pressure]].** \\ **Continue to [[:en:x200:table_of_contents|the table of contents]].** | **Continue to [[:en:x200:spindle_pressure_spring|the use of the spindle spring pressure]].** \\ |
| | **Continue to [[:en:x200:table_of_contents|the table of contents]].** |
| |
| |
en/x200/depth_regulator_nose_use.1744963112.txt.gz · Last modified: 2025/04/18 09:58 by erik.ketele
