Differences

This shows you the differences between two versions of the page.

--- en:x200:define_z-offset_when_surfacing [2025/04/18 14:55]
erik.ketele
+++ en:x200:define_z-offset_when_surfacing [2025/04/18 14:59] (current)
erik.ketele
@@ Line 13: / Line 13: @@
 ^10.^The moment the cutter tip touches the paper, which can then no longer be moved back and forth, stop pushing the Z-down key. \\ As an alternative jog the spindle down to the desired position, release the little screw in the cutter knob, gently push the cutter \\ down till it touches the material and re-tighthen the cutter knob.| ||
 ^11.^Push the key to set the plate surface.|{{:en:x300:key_surface.png?50}}||
-^12.^Push the Enter key in the "set plate surface" window. The plate surface now becomes Z=0.00 and the engraving spindle moves a little upwards.|{{:nl:x200:x200_setsurface.png?250}}||
+^12.^Push the Enter key in the "set plate surface" window. The plate surface now becomes Z=0.00 and the engraving spindle moves \\ a little upwards.|{{:nl:x200:x200_setsurface.png?250}}||
-**Ga verder naar [[:nl:x200:how_to_use_symmetry_engraving_depths|3.4.2.2. Instelling om de in Symmetry ingestelde graveerdieptes te gebruiken]].** \\
+**Continue to [[:en:x200:how_to_use_symmetry_engraving_depths|3.4.2.2. How to enter engraving depths in Symmetry]].** \\
-**Ga verder naar [[:nl:x200:inhoudstafel|de inhoudstafel]].**
+**Continue to [[:en:x200:table_of_contents|the table of contents]].**

cyborg-engravers