en:x200:define_z-offset_when_surfacing
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x200:define_z-offset_when_surfacing [2025/04/18 14:53] erik.ketele |
en:x200:define_z-offset_when_surfacing [2025/04/18 14:59] (current) erik.ketele |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| ^8.^Move the spindle down and at the same time hold a thin piece of paper under the cutter.|{{: | ^8.^Move the spindle down and at the same time hold a thin piece of paper under the cutter.|{{: | ||
| ^9.^Move that piece of paper back and forth while slowly lowering the spindle.|See image here above.|| | ^9.^Move that piece of paper back and forth while slowly lowering the spindle.|See image here above.|| | ||
| - | ^10.^The moment the cutter tip touches the paper, which can then no longer be moved back and forth, stop pushing the Z-down key. \\ As an alternative jog the spindle down the desired position, release the little screw in the cutter knob, gently push the cutter down till it touches the material and re-tighthen the cutter knob.| || | + | ^10.^The moment the cutter tip touches the paper, which can then no longer be moved back and forth, stop pushing the Z-down key. \\ As an alternative jog the spindle down to the desired position, release the little screw in the cutter knob, gently push the cutter |
| ^11.^Push the key to set the plate surface.|{{: | ^11.^Push the key to set the plate surface.|{{: | ||
| - | ^12.^Push the Enter key in the "set plate surface" | + | ^12.^Push the Enter key in the "set plate surface" |
| - | **Ga verder naar [[:nl: | + | **Continue to [[:en: |
| - | **Ga verder naar [[:nl:x200:inhoudstafel|de inhoudstafel]].** | + | **Continue to [[:en:x200:table_of_contents|the table of contents]].** |
en/x200/define_z-offset_when_surfacing.1744980790.txt.gz · Last modified: 2025/04/18 14:53 by erik.ketele
