en:x200:daily
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
en:x200:daily [2025/04/24 08:28] erik.ketele |
en:x200:daily [2025/04/24 08:29] (current) erik.ketele |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| • Vacuum clean your table and all accessible areas with a vacuum cleaner. Never use compressed air to get rid of chips, dust and debris.\\ | • Vacuum clean your table and all accessible areas with a vacuum cleaner. Never use compressed air to get rid of chips, dust and debris.\\ | ||
| • Check the status of your cutters. Do not use dull or broken cutters. To check the status of your cutters use a good magnifying glass.\\ | • Check the status of your cutters. Do not use dull or broken cutters. To check the status of your cutters use a good magnifying glass.\\ | ||
| - | • Unscrew the depth setting ring and nose and inspect the inside. Clean the inside and put some grease on the threaded lower part of the spindle before screwing the nose ring on again.\\ | ||
| **Continue to [[: | **Continue to [[: | ||
en/x200/daily.1745476104.txt.gz · Last modified: 2025/04/24 08:28 by erik.ketele
