en:x200:configuring_the_pc_ethernet_port
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
en:x200:configuring_the_pc_ethernet_port [2025/04/17 15:44] erik.ketele created |
en:x200:configuring_the_pc_ethernet_port [2025/04/17 15:46] (current) erik.ketele |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| **Note:** the below screendumps were taken from a Windows 10 environment. | **Note:** the below screendumps were taken from a Windows 10 environment. | ||
| - | Your pc will need a free Ethernet connection, which will be dedicated to the Cyborg engraver. Add a 2nd network card if needed. Connect the X-300 using the supplied CAT 6A ethernet cable. Then setup the Ethernet adapter. Go to the windows network settings, the network adapter with “No network access” is the one for the X-300:\\ | + | Your pc will need a free Ethernet connection, which will be dedicated to the Cyborg engraver. Add a 2nd network card if needed. Connect the X-200 using the supplied CAT 6A ethernet cable. Then setup the Ethernet adapter. Go to the windows network settings, the network adapter with “No network access” is the one for the X-200:\\ |
| {{: | {{: | ||
| Click on the adapter with no network access, here: " | Click on the adapter with no network access, here: " | ||
| Line 12: | Line 12: | ||
| Mark the option TCP/IP V4 only and uncheck all the other options, then click on the “properties” button.\\ | Mark the option TCP/IP V4 only and uncheck all the other options, then click on the “properties” button.\\ | ||
| {{: | {{: | ||
| - | The PC ethernet adapter gets IP Address 172.22.2.101. The Cyborg X-300 is setup for 172.22.2.100.\\ | + | The PC ethernet adapter gets IP Address 172.22.2.101. The Cyborg X-200 is setup for 172.22.2.100.\\ |
| Press OK, now you can test if the network is working, click the Windows Start button, select all programs => accessories=> | Press OK, now you can test if the network is working, click the Windows Start button, select all programs => accessories=> | ||
| In the command prompt, enter “ping 172.22.2.100” and hit the Enter key. When the connection is OK, you should see:\\ | In the command prompt, enter “ping 172.22.2.100” and hit the Enter key. When the connection is OK, you should see:\\ | ||
| Line 20: | Line 20: | ||
| {{: | {{: | ||
| If you see this problem, check your cable and your network settings again.\\ | If you see this problem, check your cable and your network settings again.\\ | ||
| - | Also check that the yellow led on the X-300 ethernet port is flashing at approximately 1Hz.\\ | + | Also check that the yellow led on the X-200 ethernet port is flashing at approximately 1Hz.\\ |
| ==== Set admin mode and switch off UAC ==== | ==== Set admin mode and switch off UAC ==== | ||
en/x200/configuring_the_pc_ethernet_port.1744897478.txt.gz · Last modified: 2025/04/17 15:44 by erik.ketele
